ZyXEL Communications VMG3926-B10A - Add;Edit Policy Route

Chapter 9 Routing
VMG3926-B10A User’s Guide
139
9.4.1 Add/Edit Policy Route
Click Add New Policy Route in the Policy Route screen or click the Edit icon next to a policy. Use
this screen to configure the required information for a policy route.
Figure 65 Policy Route: Add/Edit
The following table describes the labels in this screen.
Status This field displays whether the DNS route is active or not. A yellow bulb signifies that this
DNS route is active. A gray bulb signifies that this DNS route is not active.
Name This is the name of the rule.
Source IP This is the source IP address.
Source Subnet
Mask
his is the source subnet mask address.
Protocol This is the transport layer protocol.
Source Port This is the source port number.
Source MAC This is the source MAC address.
Source
Interface
This is the interface from which the matched traffic is sent.
WAN Interface This is the WAN interface through which the traffic is routed.
Modify Click the Edit icon to edit this policy.
Click the Delete icon to remove a policy from the VMG. A window displays asking you to
confirm that you want to delete the policy.
Table 41 Network Setting > Routing >Policy Route (continued)
LABEL DESCRIPTION
Table 42 Policy Route: Add/Edit (Sheet 1 of 2)
LABEL DESCRIPTION
Active Select this to activate this policy route.
Route Name Enter a descriptive name of up to 8 printable English keyboard characters, not including
spaces.
Source IP Enter the source IP address.
Source Subnet
Mask
Enter the source subnet mask address.
Protocol Select the transport layer protocol (TCP or UDP).