Chapter 7 Wireless
VMG3926-B10A User’s Guide
97
7.4 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your VMG.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See Section 7.9.9.3 on page 113 for more information about WPS.
Note: The VMG applies the security settings of the SSID1 profile (see Section 7.2 on
page 90). If you want to use the WPS feature, make sure you have set the security
mode of SSID1 to WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Access
Scenario
If you select Home Guest, clients can connect to each other directly.
If you select External Guest, clients are blocked from connecting to each other directly.
Max. Upstream
Bandwidth
Specify the maximum rate for upstream wireless traffic to the WAN from this WLAN in
kilobits per second (Kbps).
Max.
Downstream
Bandwidth
Specify the maximum rate for downstream wireless traffic to this WLAN from the WAN in
kilobits per second (Kbps).
Security Level
Security Mode Select Basic (WEP, 802.1X) or More Secure (WPA(2)-PSK) to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as the VMG. After you select to use a security, additional
options appears in this screen.
Or you can select No Security to allow any client to associate this network without any data
encryption or authentication.
See Section 7.2.1 on page 92 for more details about this field.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 21 Network Setting > Wireless > Guest / More AP > Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
