Chapter 6 Broadband
VMG3926-B10A User’s Guide
71
6.2.1.2 Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon
next to the connection you want to configure. Select Bridge as the encapsulation mode. The screen
varies depending on the interface type you select.
If you select ADSL/VDSL over PTM as the interface type, the following screen appears.
IPv6 DNS Select Dynamic to have the VMG get the IPv6 DNS server addresses from the ISP
automatically.
Select Static to have the VMG use the IPv6 DNS server addresses you configure manually.
IPv6 DNS
Server 1
Enter the first IPv6 DNS server address assigned by the ISP.
IPv6 DNS
Server 2
Enter the second IPv6 DNS server address assigned by the ISP.
VLAN (These fields appear when the Type is set to ADSL/VDSL over PTM.)
Active Select this to enable VLAN on this WAN interface.
802.1p IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame
that contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection.
The greater the number, the higher the priority level.
802.1q Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
QoS
Rate Limit Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
WAN Outgoing
Default Tag
Select Enable and enter a DSCP (DiffServ Code Point) value to have the VMG add it in the
packets sent by this WAN interface.
802.1p This field displays if you activate VLAN for this WAN interface. Enter a priority level (from 0
to 7) to have the VMG add it to traffic through this connection.
DSCP If you enable Select WAN Outgoing Default Tag, enter a DSCP (DiffServ Code Point)
value to have the VMG add it in the packets sent by this WAN interface.
MTU
MTU Size Enter the MTU (Maximum Transfer Unit) size for this traffic.
Bridging and
Routing in the
same WAN
Use this feature to bridge a LAN port(s) with the WAN interface. Traffic to/from LAN ports
not in the bridge is routed from the WAN interface.
ADSL use same VPI/VCI in Bridge and Route modes.
VDSL use same VLAN in Bridge and Route modes.
Enable Con-
current WAN
Enable this if you want to use the same VPI/VCI settings in different WAN interfaces. Select
this and then choose the ports to bridge with the WAN interface. \
• ADSL concurrent WAN uses the same VCI/PVI in both routing and bridge modes.
• VDSL concurrent WAN uses same VLAN in both routing and bridge mode.
Apply Click Apply to save your changes back to the VMG.
Cancel Click Cancel to exit this screen without saving.
Table 8 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
LABEL DESCRIPTION
To Next Page
Loading...
