Chapter 9 Routing
VMG3926-B10A User’s Guide
138
Figure 63 DNS Route Add
The following table describes the labels in this screen.
9.4 The Policy Route Screen
Traditionally, routing is based on the destination address only and the VMG takes the shortest path
to forward a packet. Policy route allows the VMG to override the default routing behavior and alter
the packet forwarding based on the policy defined by the network administrator. Policy-based
routing is applied to outgoing packets, prior to the normal routing.
You can use source-based policy forwarding to direct traffic from different users through different
connections or distribute traffic among multiple paths for load sharing.
The Policy Route screen let you view and configure routing policies on the VMG. Click Network
Setting > Routing > Policy Route to open the following screen.
Figure 64 Network Setting > Routing > Policy Route
The following table describes the labels in this screen.
Table 40 DNS Route Add
LABEL DESCRIPTION
Active Select this to activate this DNS route.
Domain Name Enter the domain name of the DNS route entry.
Subnet Mask Enter the subnet mask of the DNS route entry.
WAN Interface Select the WAN connection through which the VMG forwards DNS requests for this domain
name. WWAN means the wireless 3G interface.
OK Click this to save your changes.
Cancel Click this to exit this screen without saving any changes.
Table 41 Network Setting > Routing >Policy Route
LABEL DESCRIPTION
Add New Policy
Route
Click this to create a new policy forwarding rule.
# This is the index number of the entry.
To Next Page
Loading...
