Chapter 8 Home Networking
VMG3926-B10A User’s Guide
122
3 Click Apply to save your settings.
Figure 50 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 29 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
Interface Group
Group Name Select the interface group name for which you want to configure LAN settings. See Chapter
14 on page 181 for how to create a new interface group.
LAN IP Setup
IPv4 Address Enter the LAN IPv4 IP address you want to assign to your VMG in dotted decimal notation,
for example, 192.168.1.1 (factory default).
Subnet Mask/
Prefix Length
Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your VMG automatically computes the subnet mask based
on the IP Address you enter, so do not change this field unless you are instructed to do so.
IGMP Snooping
Status Select the Enable IGMP Snooping checkbox to allows the VMG to passively learn multicast
group.
To Next Page
Loading...
