Chapter 4 Web Configurator
XGS1210-12 User’s Guide
21
Figure 13 Change Administrator Login Password
4.4 Switch Lockout/Resetting the Switch
You could block yourself (and all others) from managing the Switch if you remove all ports from VLAN1
and you do not configure other VLAN groups.
Note: Be careful not to lock yourself and others out of the Switch.
Make sure to log out of the Switch from a computer before logging in again on another
computer.
If you forget the administrator password or cannot access the Web Configurator, you will need to use
the Reset button at the front panel of the Switch to reset it back to the factory defaults.
This means that you will lose all configurations that you had previously and the password will be reset to
“1234”. IP address will also be reset to 192.168.1.3.
1 Make sure the PWR/SYS LED is on (not blinking).
2 To set the device back to the factory default settings, press the Reset button for more than 6 seconds or
until the PWR/SYS LED begins to blink and then release it. When the PWR/SYS LED begins to blink, the
defaults have been restored and the device restarts.
To Next Page
Loading...
