ZyXEL Communications XGS1210-12 - Initial Setup Example; Overview and Changing the IP Address

Chapter 5 Initial Setup Example
XGS1210-12 User’s Guide
23
CHAPTER 5
Initial Setup Example
5.1 Overview
This chapter shows how to set up the Switch for use.
The following lists the configuration steps for the initial setup:
• Change the IP Address
• Changing the Password
5.1.1 Change the IP Address
If you do not wish to set your Switch as a DHCP client (DHCP client field is Disable), assign an IP address
for the Switch. The IP address makes it accessible from an outside network. It is used by the Switch to
communicate with other devices in other networks.
In this example, you want to change the IP address to 192.168.1.5.
1 Click Management in the navigation panel to open the following screen.