108
1.6 How to Set Up IPv6 Interfaces For Pure IPv6 Routing
This example shows how to configure your USG Z’s WAN and LAN interfaces which connects two IPv6
networks. USG Z periodically advertises a network prefix of 2006:1111:1111:1111::/64 to the LAN
through router advertisements.
Note: Instead of using router advertisement, you can use DHCPv6 to pass the network
settings to the computers on the LAN.
Figure 22 Pure IPv6 Network Example
1.6.1 Setting Up the WAN IPv6 Interface
1 In the CONFIGURATION > Network > Interface > Ethernet screen’s IPv6 Configuration
section, double-click the wan1.
2 The Edit Ethernet screen appears. Select Enable Interface and Enable IPv6. Select Enable
Auto-Configuration. Click OK.
Note: Your ISP or uplink router should enable router advertisement.
1.6.2 Setting Up the LAN Interface
To Next Page
Loading...
