168
2 Select the trunk as the default trunk and click Apply.
4.3 How to Use Multiple Static Public WAN IP Addresses for
LAN-to-WAN Traffic
If your ISP gave you a range of static public IP addresses, this example shows how to configure a
policy route to have the USG use them for traffic it sends out from the LAN.
4.3.1 Create the Public IP Address Range Object
Click Configuration > Object > Address > Add (in IPv4 Address Configuration) to create the
address object that represents the range of static public IP addresses. In this example you name it
Public-IPs and it goes from 1.1.1.10 to 1.1.1.17.
To Next Page
Loading...
