96
(2) Go to Configuration > Device HA > Activate-Passive Mode to add the management interface on the
master device.
The Device Role must be set as “Master”.
WAN management IP address is: 10.59.3.101
LAN management IP address is: 192.168.1.11
(3) Go to Configuration > Device HA > General to enable the Device HA function.
After you have enabled the Device HA function, you will see the interface that was monitored above.
On Backup setting:
(4) Go to Configuration > Network > Interface > Ethernet to check the WAN and LAN interface setting.
WAN interface is: 10.59.3.100/24
LAN interface is: 192.168.1.1/24
(5) Go to Configuration > Device HA > Activate-Passive Mode to add the management interface on the
backup device.
The Device Role must se as “Backup”.
WAN management IP address is: 10.59.3.102
LAN management IP address is: 192.168.1.12
To Next Page
Loading...
