ZyXEL Communications ZyWall - 10.2.1 Zone Command Examples

Chapter 10 Zones
ZyWALL (ZLD) CLI Reference Guide
113
10.2.1 Zone Command Examples
The following commands add Ethernet interfaces ge1 and ge2 to zone A and block intra-zone traffic.
Router# configure terminal
Router(config)# zone A
Router(zone)# interface ge1
Router(zone)# interface ge2
Router(zone)# block
Router(zone)# exit
Router(config)# show zone
No. Name Block Member
===========================================================================
1 A yes ge1,ge2
Router(config)# show zone A
blocking intra-zone traffic: yes
No. Type Member
===========================================================================
1 interface ge1
2 interface ge2