Chapter 3 Object Reference
ZyWALL (ZLD) CLI Reference Guide
40
3.1.1 Object Reference Command Example
This example shows how to check which configuration is using an address object named
LAN1_SUBNET. For the command output, firewall rule 3 named LAN1-to-USG-2000 is using the
address object.
show reference object zone [object_name] Displays which configuration settings reference the specified zone object.
show reference object dhcp6-lease-object
[object_name]
Displays which configuration settings reference the specified DHCPv6
lease object.
show reference object dhcp6-request-
object [object_name]
Displays which configuration settings reference the specified DHCPv6
request object.
show reference object-group username
[username]
Displays which configuration settings reference the specified user group
object.
show reference object-group address
[object_name]
Displays which configuration settings reference the specified address
group object.
show reference object-group address6
[object_name]
Displays which configuration settings reference the specified IPv6 address
group object.
show reference object-group service
[object_name]
Displays which configuration settings reference the specified service
group object.
show reference object-group interface
[object_name]
Displays which configuration settings reference the specified trunk object.
show reference object-group aaa ad
[group_name]
Displays which configuration settings reference the specified AAA AD
group object.
show reference object-group aaa ldap
[group_name]
Displays which configuration settings reference the specified AAA LDAP
group object.
show reference object-group aaa radius
[group_name]
Displays which configuration settings reference the specified AAA RADIUS
group object.
Table 6 show reference Commands (continued)
COMMAND DESCRIPTION
Router(config)# show reference object address LAN1_SUBNET
LAN1_SUBNET References:
Category
Rule Priority Rule Name
Description
===========================================================================
Firewall
3 N/A
LAN1-to-USG-2000
Router(config)#
To Next Page
Loading...
