ZyWALL (ZLD) CLI Reference Guide 181
CHAPTER 22
IDP Commands
This chapter introduces IDP-related commands.
22.1 Overview
Commands mostly mirror web configurator features. It is recommended you use the web
configurator for IDP features such as searching for web signatures, creating/editing an IDP profile
or creating/editing a custom signature. Some web configurator terms may differ from the
command-line equivalent.
Note: The “no” command negates the action or returns it to the default value.
The following table lists valid input for IDP commands.
22.2 General IDP Commands
22.2.1 IDP Activation
Note: You must register for the IDP/AppPatrol signature service (at least the trial) before
you can use it. See Chapter 5 on page 45.
Table 98 Input Values for IDP Commands
LABEL DESCRIPTION
zone_profile The name of a zone. For the ZyWALL USG 300 and above, use up to 31 characters (a-zA-Z0-
9_-). The name cannot start with a number. This value is case-sensitive.
The ZyWALL USG 200 and lower models use pre-defined zone names like DMZ, LAN1, SSL
VPN, WLAN, IPSec VPN, OPT, and WAN.
idp_profile The name of an IDP profile. It can consist of alphanumeric characters, the underscore, and
the dash, and it is 1-31 characters long. Spaces are not allowed.
To Next Page
Loading...
