2N EasyGate Pro - Page 39

User Guide 2N® EasyGate PRO
39 / 87
CLI – calling number (Function No. –)
Fill in CLI to route the call according to the parameter on the same table row. It is possible to fill
in only a prefix for a group of CLI's. If the parameter "Substring" = 0, you must fill in the prefix
you see on your mobile phone display. It means inclusive of + and the international prefix if
included. If "Substring" > 0,2N
®
SmartGateUMTS searches the filled-in prefix as a substring of
the received CLI, but at most to the position given by the "Substring" parameter. The positions
are counted from zero. See examples in the "Substring" parameter hint.
Setting options: 0–16 characters (0–9, *, #, +)
Default setting: blank

Substring (Function No. –)
The parameter is used for making the completion of the CLI prefix easier. If the parameter
"Substring" > 0,2N
®
EasyGate searches the filled-in prefix as a substring of the received CLI, but
at most to the position given by the "Substring" parameter. The positions are counted from
zero.
For example: the received CLI +420603198222 corresponds with the following settings:
CLI – calling number Substring
+420603198222 any setting
+420603 any setting
+420 any setting
603198222 4 or more
603 4 or more
Setting options: 0–15
Step: 1
Default setting: 0
•
Caution
Configuration using phone line programming (DTMF) is applicable for 'Other
prefixes' only.
