2N EasyGate Pro User Manual

User Guide 2N® EasyGate PRO
54 / 87
•
•
•
•
•
•
•
1.
2.
3.
4.
5.
6.
1.
4. Function and Use
This section describes the basic and extending functions of the product2N
®
EasyGate PRO.
Here is what you can find in this section:
4.1 Voice Function
4.2 FAX and Data Function
4.3 SMS Sending Input
4.4 Data Connection Using USB Port
4.5 SIM Card PIN protection
4.6 Free minutes option
4.7 Lift Functions
4.1 Voice Function
Outgoing and incoming call establishing procedures for an analog telephone are described for
illustration. The procedures are the same for the EasyGate-PBX connection, just remember to
program call routing to EasyGate properly. Check EasyGate's function by connecting a
telephone before.
Suppose that a SIM card has been inserted, the PIN code entered or not required, the antenna
connected and EasyGate registered to GSM network – the GSM network LED is permanently on
and you can hear the dial tone upon off-hook.
Outgoing Call
Hook off the telephone, you can hear the dial tone and the Line LED starts flashing.
Dial the required GSM subscriber number. Since EasyGate receives tone dialing by default,
select the DTMF mode. If your telephone transmits pulse dialing only, program EasyGate
to receive pulse dialing. The delay between digits to be dialed may not exceed 5 s
(programmable parameter). The number is evaluated as complete and transmitted to the
GSM network after this timeout.
A short delay follows the last-dialed digit for EasyGate to await further dialing. Then, the
dialing end is signaled and connection is established.
If the called subscriber is available, you can hear the ringing tone. If not, you can hear the
busy tone or any of the GSM provider's messages.
When the called subscriber answers the call, a call is established. The Line LED is
permanently on during the call.
Hang up to terminate the call. The Line LED goes off. If the called subscriber is the first to
hang up, you can hear the busy tone and hang up.
Incoming Call
Ringing signals an incoming call. The Line LED flashes during ringing. If programmed so,
EasyGate transmits the CLIP by FSK between the first and second rings. Advanced
telephone sets are able to display the CLI.

2N EasyGate Pro Specifications

General

Mounting	DIN-rail
Device type	Cellular network gateway
Built-in display	No
Market positioning	Business
Data network	GSM
SIM interface	3 V
GSM bands supported	850, 900, 1800, 1900 MHz
USB port	Yes
USB 2.0 ports quantity	1
Antenna connector type	SMA
Input voltage	100 - 240 V
Operating temperature (T-T)	0 - 45 °C

Weight and Dimensions

Dimensions (WxDxH)	163 x 157 x 38 mm