User Guide 2N® EasyGate PRO
•
•
•
•
1.
2.
3.
4.
5.
3. 2N®EasyGate PRO Configuration
This section describes configuration of the product2N
®
EasyGate PRO.
Here is what you can find in this section:
3.1 2N® EasyGate Pro Parameter Configuration
3.2 Table of Parameters
3.1 2N® EasyGate Pro Parameter Configuration
PC Connection
A USB cable is added to the package. Use it for the PC and EasyGate interconnection.
EasyGate Parameter Programming
All EasyGate parameters have such default values that meet most users' demands and need not
be changed. To change EasyGate parameters in spite of that, you can either:
Use a PC with PCManager UNI installed. All the functions supported by EasyGate can be set
using the PC.
Or use DTMF programming on a telephone line. Not all functions can be set in this way.
Telephone Line Based Programming
Hook off the phone, you can hear the dial tone or the busy tone and the Line LED starts
flashing.
Enter the service password (12345 by default, can be changed) using DTMF; to cancel a
wrong password hang up before sending the character.
To confirm the password enter a .
If you have entered a correct password, you hear the confirmation tone. If not, the dialed
number may be sent to the GSM network as a call. To prevent this, hang up when you do
not hear the confirmation tone.
EasyGate shall remain in the programming mode until the hang-up.
•
Caution
If another USB cable is used, make sure that a longer cable works properly to avoid
errors at high transmission rates.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
