To Next Page

To Previous Page

User Guide 2N® EasyGate PRO

62 / 87

Connection using IP stack

Function IP stack is available on special versions of EasyGate only. It is dedicated for connection

of device with embedded analogue modem to defined server on internet public address. The

connection must be initialized by connected device with embedded analogue modem by special

dialing prefix *02*. EasyGate will establish data channel to preset server by TCP connection.

4.3 SMS Sending Input

This universal input is intended especially for reporting alarm or error statuses of any equipment

provided with the appropriate contact (a relay contact, e.g.).

By activating this input (electric input pin interconnection) you send one SMS to one pre-

programmed telephone number.

SMS input isn’t available on EasyGate UMTS versions without battery backup. If is this input

needed, use the battery version.

4.4 Data Connection Using USB Port

The EasyGate device is equipped with a virtual serial port that simulates the standard COM port

in a PC according to specification RS-232C. The installation is described in Subs. 3.1 "Installation

and Setting of EasyGate PCManager", points 1 to 3.

The transmission rate ranges from 1200 to 115200 bps (EasyGate supports autobauding, i.e.

responds to an AT command at a rate identical with the AT command transmission rate, and

remains set on this rate). The transmission setup must be 8 bits, no parity and one STOP bit

(8N1).

During the call establishing and terminating the serial interface of the GSM module is used by

the EasyGate central processor. During this time the communication with the module is

impossible. The communication is blocked by setting of the signals for flow control on the

virtual COM port. All PC SW must provide transmission hardware flow control (HW handshaking).

CSD PC-PC Data Transmission

The CSD mode provides data transmission in the GSM network at the maximum transmission

rate of 14400 bps. It works like a classic connection of two modems (AT commands ATD, ATH,

ATA, etc.). Connection can be made with another GSM modem or a PSTN modem.

•

Caution

Do not use in life-supporting or property-protection applications because of the

character of SMS service and EasyGate. The manufacturer shall not be liable for

health and property damage incurred as a result of SMS sending failure.



Other manuals for 2N EasyGate Pro

Questions and Answers:

Need help?

Do you have a question about the 2N EasyGate Pro and is the answer not in the manual?

General