To Next Page

To Previous Page

User Guide 2N® EasyGate PRO

68 / 87

•

Automatic PIN Entering

You need not enter the PIN upon power up if it is stored in EasyGate – it is entered automatically.

This function is convenient in case of power failure; EasyGate is operable in a short time after

power recovery without any intervention by the operating staff.

4.6 Free minutes option

Basic description

With Firmware 3.5x only!

Free minutes option allows user to control amount of minutes used for four groups of operators

in one month period. The user than knows, if performed calls are included in free minutes

bundle, or if he has to pay extra price for it. Calls for extra price can be disabled. All setting done

by customer is accessible by DTMF setting.

Setting of prefixes (operators) in four banks can be changed using PCManager. This setting, the

amount of free minutes in every bank and rules for time counting are preset from factory.

Programming of parameters is done the same way like programming of all other gateway

parameters. To change free minutes option parameters, you can either:

Use the DTMF programming on a telephone line. There are parameters, which can be

programmed using telephone line based programming with password access as described

in part 3.1 and commands with direct access, used the same way as command for

configuration of network services as described in part 4.1.

Use a PC with the PCManager installed.

Parameters – password access

Call with empty bank permitted(Function No.: 310)

The call with empty Bank is either disabled or permitted. When the bank is empty, you hear after

dial refusing tone. With call disabled is followed by Busy tone and the call can’t be established.

With call permitted you can hang up the call, otherwise the call is established and charged.

Setting options:  0/1 (disabled / permitted)

•

Warning

One PIN entering option is exhaustedby the attempt to enter the PN

automatically upon SIM card or PIN change. If wrong, the automatically entered

PIN is cleared from the internal memory to avoid another false attempt upon next

power on. There are still two manual PIN-entering attempts after such

unsuccessful automatic entering. To prevent the unsuccessful automatic PIN

entering, delete or program properly the EasyGate PIN using the PCManager in the

case of SIM card change.



Other manuals for 2N EasyGate Pro

Questions and Answers:

Need help?

Do you have a question about the 2N EasyGate Pro and is the answer not in the manual?

General