2N EasyGate Pro - Page 47

User Guide 2N® EasyGate PRO
47 / 87
Service
Hardware version
2N
®
EasyGatehardware version – for information only (cannot be modified). Must be used for
communication with the manufacturer.

Firmware version
2N
®
EasyGatefirmware version –2N
®
EasyGate central processor program version. The
manufacturer can issue upgrades to extend functions. To load new firmware into2N
®
EasyGate,
use the Upgrade function. Keep communicating with the manufacturer.

Serial number
2N
®
EasyGateserial number– for information only (cannot be changed). Must be used for
communication with the manufacturer.

Blocked for operator
Refer to GSM & SIM Parameters.

COM enable (Function No. 960)
With this parameter you can enable/disable the serial interface function. You can disable
communication in the operating mode, maintaining the special programming mode after power
up.
Setting options: YES/NO
Default setting: YES

Time limit for data connections(Function No. 961)
After the time elapses, the data/fax connection is terminated immediately without warning. The
"0" setting means that the function is disabled.
Setting options: 0–255 min
Step: 1 min
Default setting: 0

Telephone number for service SMS Function No.: 714