User Guide 2N® EasyGate PRO
the confirmation tone. A successful setting is followed by a pause (approx.10 s), during which
reset of the configuration memory is performed. Then the gateway is restarted.
Security Parameters
PIN – value (Function No. 700)(SIM2-750)
Fill in the PIN value for automatic PIN entering upon the2N
®
EasyGate power up. It is applied
only if the SIM card is PIN secured. If the given PIN fails to match the SIM, it is deleted
automatically. If entered via a telephone line upon the2N
®
EasyGate start, the PIN is stored
automatically.
Setting options: 0, 4–8 characters (0–9)
Upon full initialization: blank
Service password (Function No.900)
Fill in the service password for programming via a telephone line. Some parameters can be
programmed by DTMF dialing and so the access to programming must be password-protected.
Setting options: 4–8 characters (0–9)
Upon full initialization: 12345
Lift application (optional)
Battery error signalization Function No.: 964
Set battery error signalization protocol. Using Lift1 setting is only for connection with 2N Lift1
communicator. Gateway reports error to Lift1 and then Lift1 makes call to monitoring center.
Setting options: Off
Using Lift1
P100 not active
P100 2N extended not active
Default setting: Off
FXS line voltage break Function No.: 965
You can set signalization of network registration and powering state by voltage break on FXS
line interface. FXS Line voltage is disconnected all time when selected problem lasts.
Setting options: Off -Function is off, FXS line voltage is allways on
Network error -FXS line voltage break when not registered to network
To Next Page
Loading...
