2N Helios IP - Helios IP Safety Configuration

2N® Helios IP Safety Configuration
3.1
28
3.1 2N
®
Helios IP Safety Configuration
Use a PC equipped with any web browser to configure 2N
®
Helios IP Safety:
 Launch your web browser (Internet Explorer, Firefox, etc.).
 Enter the IP address of your intercom (http://192.168.1.100/, e.g.).
 Log in using the Admin user name and 2n password.
You have to know the IP address of your device to log in to the integrated web server.
By default, 2N
®
Helios IP Safety is switched into the dynamic IP address mode, i.e. it
obtains the IP address automatically if a properly set DHCP server is available in your
LAN. If no such DHCP server is available, you can operate 2N
®
Helios IP Safety in the
static IP address mode. Refer to the 2N
®
Helios IP Configuration Manual for
configuration details.
If your device remains inaccessible (you have forgotten the IP address, or the LAN
configuration has changed, for example), change the LAN settings using the buttons
on the device.
Switching between Static and Dynamic IP Address
 Connect 2N
®
Helios IP Safety to the power supply (or, disconnect and
reconnect it if already connected).
 Wait for the first acoustic signal .
 Press button 1 15 times.
 The acoustic signal indicates mode switching.
 Wait until the device is restarted automatically.
Note: The 15 times 1 sequence must be entered within 30 seconds after the first
sound signal for security reasons. The inter-digit delay may be 2s at most.
The static IP address mode will be switched into the dynamic IP address mode and
vice versa upon restart.