2N Helios IP Documentation

Helios IP – Documentation Page 5
Device Connection
The Helios IP device is connected to the Local Area Network. The intercom is supplied via PoE or an
external power supply.
Device Configuration
API Access
Make basic configuration after connecting the device to the LAN.Default access values are (Login:
admin, Password: 2n). The C4 - Helios IP communication runs via the intercom HTTP API. Set the API
login data and enable the API functions to access this function. Go to the Services menu and select the
HTTP API submenu via the Helios IP web interface. Enable the functions, select the TLS or TCP
connection type and set the authentication type to None or Basic as shown in the figure below.
Figure 1: HTTP API Settings

2N Helios IP Specifications

General

Type	IP Intercom
Connectivity	Ethernet
Tamper Switch	Yes
Audio	Full duplex
Microphone	Built-in
Speaker	Built-in
Camera	Yes
Power Supply	PoE
Operating Temperature	+60°C
Ingress Protection	IP54
Protocols	SIP, RTSP, ONVIF
Audio Codec	G.711, G.722
Installation	Surface mount, flush mount (depending on model)