2N Helios IP Documentation

Helios IP – Documentation Page 17
TCF020A Property Value Out Of Range
The test verifies configuration containing a value beyond the allowed range. The test verifies whether the
driver is able to detect this error at initialisation.
Test Procedure
1. Stop the driver if running.
2. Add a driver with an ID higher than that of Helios IP.
3. Run the device.
Expected Results
1. The driver is not initialised and stops.
2. The driver with a wrong ID passes into the ConfigurationFailure state.
3. The following event is recorded in the log:
Invalid property value ‘VALUE’ on ‘DEVICE’.
Where
 VALUE is the wrong ID value.
 DEVICE represents the device name.

2N Helios IP Specifications

General

Type	IP Intercom
Connectivity	Ethernet
Tamper Switch	Yes
Audio	Full duplex
Microphone	Built-in
Speaker	Built-in
Camera	Yes
Power Supply	PoE
Operating Temperature	+60°C
Ingress Protection	IP54
Protocols	SIP, RTSP, ONVIF
Audio Codec	G.711, G.722
Installation	Surface mount, flush mount (depending on model)