2N Helios IP Documentation

Helios IP – Documentation Page 15
Basic Function Tests
TCF000A Duplicated Addresses
The test verifies the presence of a switch with duplicate identifier.
Test Procedure
1. Stop Helios PI using the Stop button.
2. Create two switches in the device.
3. Set identical Digital Output IDs for the two switches.
4. Start the Helios IP driver using the Reinitialisation button.
Expected Results
1. The two switches pass into the ConfigurationFailure status.
2. The driver is not initialised and stops.
3. The following record appears in the log:
At ‘DEVICE1’ and ‘DEVICE2’ nodes of ‘DRIVER’ a duplicate address ‘ADDRVALUE’ was
detected.
Where
 DEVICE1 a DEVICE2 represent the names of the duplicate switches.
 DRIVER represents the device name.
 ADDRVALUE is the switch ID.

2N Helios IP Specifications

General

Type	IP Intercom
Connectivity	Ethernet
Tamper Switch	Yes
Audio	Full duplex
Microphone	Built-in
Speaker	Built-in
Camera	Yes
Power Supply	PoE
Operating Temperature	+60°C
Ingress Protection	IP54
Protocols	SIP, RTSP, ONVIF
Audio Codec	G.711, G.722
Installation	Surface mount, flush mount (depending on model)