2N IP series Automation Manual

2N TELEKOMUNIKACE a.s., www.2n.cz 25/104
CardHeld
The block defines the event generated by holding of the RFID card with the CardHeld
defined ID (for RFID card reader models only). The event is generated by holding the
RFID card for 4s at the RFID card reader.
Input parameters
Card – define the RFID card ID; refer to the Card Reader subsection in the
.Configuration Manual
Valid values:
valid – any valid card (included in the intercom card list)
invalid – any invalid card
any – any valid or invalid card
SuppressTones – suppress sound signalling initiated by detection of an invalid
card. The parameter is optional.
Valid values:
disabled – tones are not suppressed
enabled – tones are suppressed (default value).
Reader – define used card reader / module
Valid values:
internal_cardreader – internal card reader ( )2N IP
®
Vario, Force
external_cardreader – external card reader ( )2N
®
IP Vario, Force
<module_name> – module name configured in the Module Name
parameter in the Hardware / Extenders / Modules / Used module
menu ( )2N
®
IP Verso
any – any reader / module
The parameter is optional, the default value is .any
Direction – define direction
Valid values:
in – reader with defined incoming direction
out – reader with defined outgoing direction
any – both directions
The parameter is optional, the default value is .any
Output parameters

2N IP series Specifications

General

Category	Intercom System
Network Interface	10/100 Mbps Ethernet
Connectivity	Ethernet
Integration	SIP
Ingress Protection	IP54
Operating Voltage	12V DC
Audio Codec	G.711
Supported Protocols	SIP, RTSP, HTTP, HTTPS
Supported Languages	Multiple