2N IP series Automation Manual

2N TELEKOMUNIKACE a.s., www.2n.cz 38/104
AudioLoopTest
The block defines the event generated after the loudspeaker and AudioLoopTest
microphone test (Audio Loop Test) is performed. The subsequent actions are
executed based on the test result.
Input parameters
Result – this parameter specifies the required test result.
Valid values:
any – the event is generated whenever the test is performed
(regardless of the result).
passed – the event is generated whenever the test is successful.
failed – the event is generated whenever the test fails.
The parameter is optional, the default value is .failed
Output parameters
Event – the Event invoke connected Event or Action.
Example
An event generated after the audio loop test if the test result is negative (i.e. the
microphone or loudspeaker is out of order):

2N IP series Specifications

General

Category	Intercom System
Network Interface	10/100 Mbps Ethernet
Connectivity	Ethernet
Integration	SIP
Ingress Protection	IP54
Operating Voltage	12V DC
Audio Codec	G.711
Supported Protocols	SIP, RTSP, HTTP, HTTPS
Supported Languages	Multiple