2N IP series Automation Manual

2N TELEKOMUNIKACE a.s., www.2n.cz 40/104
MotionDetected
The block defines the event generated at motion detection. Motion MotionDetected
can be detected by the internal camera only. The Motion detection Input parameters
are configured in the Hardware / Camera / Internal Camera menu, section Motion
Detection Settings.
Input parameters
State – define whether the start or the end of the motion should be detected.
Valid values:
start – start of the motion
end – end of the motion
The parameter is optional, the default value is .start
– internal camera source onlySource
Output parameters
Event – the Event invoke connected Event or Action.
Example
Event generated at the start of the motion.

2N IP series Specifications

General

Category	Intercom System
Network Interface	10/100 Mbps Ethernet
Connectivity	Ethernet
Integration	SIP
Ingress Protection	IP54
Operating Voltage	12V DC
Audio Codec	G.711
Supported Protocols	SIP, RTSP, HTTP, HTTPS
Supported Languages	Multiple