SendHttpRequest
The block defines the action necessary for sending of an HTTP SendHttpRequest
command to another LAN device. The HTTP command helps you control other
devices in the LAN (IP relay, recording system, another intercom, etc.).
Parameters
– define the event to launch the action.Event
– define the condition to be met to execute the action. This parameter Condition
is optional.
– define the standard HTTP URI including the destination address and, Uri
optionally, the path and other parameters.
– define the username in case authorisation is required by the HTTP Username
server. This parameter is optional. The default value is "helios".
– define the password in case authorisation is required by the HTTP Password
server. This parameter is optional.
Example 1)
Whenever a connected event is generated, HTTP sends a request to the following IP
address: 10.27.24.6:
Example 2)
Whenever any key is pressed, its exact identification is sent to the following IP
address: 10.27.24.6:
To Next Page
Loading...
Need help?
General
