66 CHAPTER 3: CONFIGURING A WX SWITCH FOR BASIC SERVICE
models. To specify the antenna model, use the set {ap | dap} radio
antennatype command. (See “Configuring Radio-Specific Parameters”
on page 73.)
To verify the configuration changes, use the following commands. Use
display ap config for directly connected MAPs and use display dap
config for Distributed MAPs. (See “Displaying Radio Configuration
Information” on page 74 for an example.)
display ap config [port-list [radio {1 | 2}]]
display dap config [dap-num [radio {1 | 2}]]
The following example sets ports 1, 2, and 4 for MAP access point model
AP2750:
WX1200# set port type ap 1,2,4 model ap2750 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
success: change accepted.
To verify the configuration change, use the following command:
display ap config [port-list [radio {1 | 2}]]
Here is an example:
WX1200# display ap config 1
Port 1: MAP model: AP2750, POE: enable, bias: high, name: MAP01
boot-download-enable: YES
load balancing group: none
Radio: type: 802.11g, mode: disabled, channel: 6
tx pwr: 15, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Configuring for a Distributed MAP To create a configuration for a
Distributed MAP (referred to as a DAP in the CLI), use the following
command:
set dap dap-num serial-id serial-ID
model {ap2750 | mp-52 | mp-101 | mp-122 | mp-241 | mp-252 |
mp-262 | mp-341 | mp-352}
[radiotype {11a | 11b| 11g}]
The dap-num parameter identifies the Distributed MAP connection for
the MAP.
To Next Page
Loading...
