3Com CS/2500 - Page 112

4I
NDEX
R
rack mount 1-10, 2-2
RAM, replacing 5-13
RARP protocol 4-10
RBCS server
Boot Protocol parameter 4-8
booting from 3-2
dumping memory to 6-5, C-6
installing software 3-2
Network Boot String parameter 4-8
reboot
Auto-Reboot parameter 4-6
number of reboots 4-7
remote 3-3
Remote Boot and Configuration Service server. See
RBCS server
remote reboot 3-3
removing cover 5-6
repeating firmware command C-6
replacing
cover 5-15
diskette drive 5-8
EPROMs 5-14
fuse 5-2
memory chips 5-13
power supply module 5-10
requirements 1-10
reset
soft C-6
switch 1-6
returning products for repair D-4
Reverse Address Resolution Protocol. See RARP
protocol
RS-232 ports
configuration 4-13
description 1-7
pin assignments A-1
RS-422 ports
configuration 4-13
description 1-8
pin assignments A-3
S
Self Test LED 1-5, 3-2, 3-7, 3-8
self-test, continuous 4-6
serial cables, attaching 2-5
serial ports
description 1-7
pin assignments A-1
Server IP Address parameter 4-11
servicing. See maintenance and upgrades
shipping damage 2-1
shutting down 3-8
SLP 4-8
soft reset C-6
software
compatibility 1-2
configuration 4-1
parameter values 4-1
running earlier versions 4-12
specifications 1-10
startup
entering monitor C-2
from diskette 3-3, 3-6
from network 3-1
from RBCS server 3-2
from TFTP/FTP server 3-3
messages 3-7, B-1
options 3-1
problems 3-8, 6-1 to 6-3
See also booting
subnet mask value 4-11
System Default Configuration menu 4-12
System Load Protocol. See SLP
T
tabletop mount 2-2
technical support D-1
terminals, cabling 2-4
TFTP Upload Path parameter 4-11
TFTP/FTP server
Boot Protocol parameter 4-8
booting from 3-3
dumping memory to 6-6, C-6
installing software 3-2
IP/TFTP parameters 4-9
Network Boot String parameter 4-8
TFTP protocol 4-8
ThreeComForum D-2
transceiver connector
cabling 2-7
description 1-9
pin assignments A-4
Trivial File Transfer Protocol server. See TFTP/FTP
server
troubleshooting
boot problems 3-8
memory dump 6-5 to 6-8
operating problems 6-3 to 6-5
CS2500BookFile : CS2500BookFileIX Page 4 Thursday, December 11, 1997 10:44 AM