2
I
NSTALLATION
This chapter describes how to install your CS/2500 series server,
including cabling the server to other devices on your network.
CAUTION:
To eliminate cable noise emission in excess of FCC Part 15
Subpart J, VDE 0871, or CISPR22 (EN55022) for Class A devices, all
cables should be triple-shielded (Inmac® 536888 or equivalent) and
have connectors with metallic backshells. Cable shields should be
connected to backshells.
Preparation
Do the following before beginning the installation:
1 Remove the server from its shipping carton.
2 Verify that you have received all items on the packing list.
3 Inspect the server for shipping damage.
If you find any damage, contact the shipping company to file a report. If
you must return the server to your network supplier or 3Com, ship it in
its original shipping carton. If the original carton was damaged in
shipment, repack the server in a carton that provides equivalent
protection.
4 Verify that the power specifications listed on the product identification
label on the back panel correspond to the available power source.
If the available power source is not within the acceptable range, contact
3Com or your network supplier.
5 Write down the Ethernet address, part number, and serial number listed
on the product identification label.
CS2500BookFile : Installation Page 1 Thursday, December 11, 1997 10:44 AM
To Next Page
Loading...