Modifying the Firmware Configuration 2-9
The AC power source must meet the requirements outlined in
“Specifications” on page 1-11. The server must be connected to its AC
power source with a grounded line cord to meet safety requirements.
Modifying the
Firmware
Configuration
The CS/2500 series server’s firmware is preset at the factory for basic
installations; in most cases you do not need to reconfigure it.
If you want to customize your server’s operation, you may need to
modify the default settings of certain firmware parameters. You can
access these parameters through the monitor utility. For information on
firmware configuration and the monitor utility, refer to Chapter 4,
“Configuration,” and Appendix C, “Monitor Utility. “
CS2500BookFile : Installation Page 9 Thursday, December 11, 1997 10:44 AM
To Next Page
Loading...