3Com CS/2500 - Page 6

vi
2
I
NSTALLATION
Preparation 2-1
Mounting the Server 2-2
Mounting on a Table 2-2
Mounting in a Rack 2-2
Mounting on the Wall 2-4
Cabling the Server to the Network 2-4
Cabling Hosts, Terminals, and Modems 2-4
Attaching RS-232 and RS-422 Serial Cables 2-5
Cabling a Console 2-5
Attaching a Transceiver Cable 2-7
Attaching a Printer Cable 2-7
Attaching the Power Cable 2-8
Modifying the Firmware Configuration 2-9
3
S
TARTUP
Booting from the Network 3-1
Installing Software on an RBCS Server 3-1
Installing Software on a Generic TFTP/FTP Host 3-2
Booting from an RBCS Server 3-2
Booting from a Generic TFTP/FTP Host 3-3
Remote Reboot 3-3
Booting from Diskette 3-3
Copying and Formatting Diskettes 3-3
Formatting Diskettes without the Copy Command 3-6
Booting the Communications Server 3-6
Normal Startup Messages 3-7
Boot Problems 3-8
Shutting Down 3-8
4
C
ONFIGURATION
Entering the Firmware Monitor 4-1
Changing the Configuration 4-3
Console Baud Rate 4-6
Console Port 4-6
Continuous Self-Test 4-6
CS2500BookFile : CS2500BookFileTOC Page vi Thursday, December 11, 1997 10:44 AM