3D Systems, Inc.
p/n: 15-D100, rev. D
1
1
2
3
4
5
6
Feed/Build Platform Movements
Note: It is required to home the platforms to ensure an accurate position display. A warning symbol will
has been pushed or the 24V power supply has been disconnected.
CAUTION: When the feed or build module is moved fully up while still containing powder, this powder will be
spilled inside the process chamber. To stop automatic movement, press the escape button on the keyboard.
system are +/- 0.03% of the step size, with a minimum of +/- 5 µm.
Tip: When the shift button is held while pressing one of the buttons of a feed platform, both feed platforms
will perform the same action.
Warning: The build platform can only be moved
up when the coater is not moving and at a known
position at one of the limit sensors. When the
coater is at an unsafe position, a yellow warning
triangle is shown.
To Next Page
Loading...
