3D Systems DMP Flex 350 - Automatic Laser Power Calibration

3D Systems, Inc.

p/n: 15-D100, rev. D
  
A. Requirements
PERFORMED BY ESTIMATED TIME TOOLS REQUIRED

Engineer

 
 
 
 
 
 
 
B. Protective personnel equipment
WARNING: MAKE SURE ALL SAFETY PRECAUTIONS ARE FOLLOWED AS SPECIFIED IN THE USER GUIDES AND IN
THE SERVICE TRAINING PROGRAM.
WARNING: ALWAYS BE AWARE OF THE RISKS INVOLVED WITH LASER RADIATION. MAKE SURE THE LASER IS
TURNED OFF WHEN THE PRINTER DOOR IS OPEN.
C. Procedure


 
15-D98 - DMP Factory 350 - User Guide.
 





 


 
