3D Systems, Inc.
p/n: 15-D100, rev. D
WARNING: ANY TIME POWDER MATERIAL IS HANDLED (I.E., REFILLING, SIFTING, CHANGING, ETC.) MAKE SURE
YOU ARE EITHER STANDING ON AN ANTI-STATIC MAT, OR YOU ARE WEARING A GROUNDING STRAP THAT IS
ATTACHED TO THE MODULE SO THAT YOU ARE GROUNDED TO THE MACHINE. ALWAYS POUR OR SCOOP SLOWLY
FROM AS CLOSE TO SURFACE AS POSSIBLE TO AVOID PRODUCING DUST FROM MATERIAL. IT IS ALSO ADVISED
THAT THE VACUUM DUST EXTRACTOR BE OVER TOP OF THE BIN.
CAUTION: The print plate must be compatible with the print material.
Caution: The build plate can be quite heavy. Take
special care when installing the build plate onto
the build platform.
To Next Page
Loading...
