11
Operation (continued)
Manually turn tape roll to create slack tape while
pulling threading needle through tape applying
mechanism until needle is through and tape is in
alignment with applying roller.
Excess tape can be cut with a scissors at applying
roller.
Figure 3-4
Place tape roll on tape drum to dispense tape with
adhesive side forward. Seat tape roll fully against
back fl ange of drum. Adhere tape lead end to
threading needle as shown.
Figure 3-4 Tape Loading/Threading
Figure 3-5 Tape Loading/Threading
• To reduce the risk associated with
sharp blade hazards:
- Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
AccuGlide 3 - 2" - NA
2013 April
WARNING
To Next Page
Loading...
