22
7-INSTALLATION (continued)
2014 June
7000r-7000r3 Pro - NA
7.5 Removal of Plastic Ties
Cut the plastic which attaches the top head to the
frame and remove the polystyrene blocks (Figure 7-4).
Cut the plastic strap which attaches the strip and the
EMERGENCY STOP cable to the frame
(Figure 7-5).
Cut the plastic ties holding the lower taping head in
position
(Figure 7-6).
Figure 7-5
Figure 7-6
Note – A tool kit consisting of metric open end
and hex socket wrenches is provided with
the machine. These tools should be
adequate to set-up the machine, however,
other tools supplied by the customer will be
required for machine maintenance
(see
the Technical Documentation/Spare Parts-
Order Section)
.
7.6 Assembly Completion / Machine Set-up
Figure 7-4
To Next Page
Loading...
