39
12-OPERATION
12.1 Operator's Correct Working Position and
Operational Flow (Figure 12-1).
12.3 Starting Production
Let the machine run without cartons and check its safety
devices. Then start the working cycle.
12.4 Tape Replacement and Threading
See Manual 2 or 3: AccuGlide™ 3 Taping Heads -
2 Inch or 3 Inch.
Press the LATCHING EMERGENCY STOP BUTTON.
12.5 Box Size Adjustment
Repeat all the operations shown in
Section 11 - Set-Up and Adjustments.
12.6 Cleaning
Before carrying out any cleaning or maintenance
operation stop the machine by turning the OFF switch on
the main and disconnect the electric power (Figure 12-4).
12.7 Table of Operation Adjustments
Operator Qualifications:
1 Tape loading and threading 1
2 Tape web alignment 1
3 Adjustment of one way tension roller 1
4 Adjustment to box size (H and W) 1
5 Top fl ap compression rollers 1
6 Adjustment of tape applying spring 1
7 Conveyor bed height adjustment 1
8 Special Adjustment-Changing tape leg length 2
9 Special Adjustment-Column re-positioning 2
12.8 Safety Devices Inspection
1 Taping units blade guard
2 Latching emergency stop button
3 STOP (OFF) main switch
12.2 Starting the Machine
Important: Before starting the machine, verify that no
tools or other objects are on the conveyor bed.
After the EMERGENCY BUTTON is released
(Figure 12-1):
- Restart machine by turning the On/Off switch to the Off
position and then to the On position (Figure 12-4).
- Then press the Station "Start" Button (Figure 12-5)
.
2014 June
7000r-7000r3 Pro - NA
Figure 12-1
Once the box has been
fi lled, close its top fl aps and
push it between the top and
bottom drive belts. Always
keep hands in position as
shown in Figure 12-2.
The box will be automatically
sealed with adhesive tape
on the top and bottom box
seams. Then the box will
be expelled (exit conveyor
is optional).
Figure 12-2
Hand
Position
"On-Off"
Figure 12-3
Figure 12-4
Figure 12-5
"Start/Stop"
To Next Page
Loading...
