15
2010 January
700rks-NA
Minimum* Maximum Refer to Minimum Maximum Refer to
mm [Inches] mm [Inches] Illustration mm [Inches] mm [Inches] Illustration
120 [4-3/4] 645 [25-1/2] A 280 [11-1/8] 810 [31-7/8] D
175 [6-7/8] 700 [27-5/8] B 275 [10-7/8] 805 [31-5/8] E
230 [9] 755 [29-3/4] C 385 [15-1/8] 910 [35-7/8] F
4-SPECIFICATIONS (continued)
Specifi cations
6. Tape Roll Diameter
Up to 405 mm [16 inch] maximum on a 76.2mm [3 inch] diameter core.
(Accommodates all system roll lengths of Scotch
®
fi lm tapes.)
7. Tape Application Leg Length – Standard
70mm ± 6 mm [2.75 inch ±. 25 inch ]
Tape Application Leg Length – Optional
50mm ± 6mm [2 inch ±. 25 inch]
(See "Removing Taping Heads Procedure – Changing the Tape Leg Length")
8. Box Board
Style – regular slotted containers – RSC
125 to 275 P.S.I. bursting test, single wall or double wall B or C fl ute.
23-44 lbs. per inch of width Edge Crush Test (ECT)
9. Box Weight and Size Capacities
A. Box Weight, fi lled: 5 lbs.–65 lbs. [2.3 kg–29.5 kg]. Contents must support fl aps.
B. Box Size: Minimum Maximum
Length: 150mm [6.0 inch] Unlimited
Width: 175mm [7.0 inch]* 645mm [25.5 inch]
Height: 120mm [4.75 inch]** 645mm [25.5 inch]
*Boxes narrower than 200mm [8 inches] may require more frequent belt replacement because of limited
contact area.
** Minimum/maximum box height dimensions are with machine at factory setting. To accommodate
smaller or larger boxes, machine upper taping head frame and/or outer column assemblies can be re-
positioned as described in the "Special Set-Up Procedure" section of this manual. Refer to chart below
for box height range desired and then to illustration indicated for machine adjustments necessary.
Minimum/Maximum Box Height Combinations
Note: Shaded area on chart indicates machine setting as shipped from factory.
To Next Page
Loading...
