39
12-OPERATION
12.1 Operator's Correct Working Position and
Operational Flow (Figure 12-1).
12.3 Starting Production
Let the machine run without cartons and check its
safety devices. Then start the working cycle.
12.4 Tape Replacement and Threading
See Manual 2: AccuGlide™ 3 Taping Heads - 3
Inch.
Press the
LATCHING EMERGENCY STOP BUTTON.
12.5 Box Size Adjustment
Repeat all the operations shown in
Section 11 - Set-Up and Adjustments.
12.6 Cleaning
Before carrying out any cleaning or maintenance
operation stop the machine by turning the OFF
rotary switch on the main and disconnect the electric
power (Figure 12-3).
12.8 Safety Devices Inspection
1 Taping units blade guard
2 Latching emergency stop button
3 STOP (OFF) main rotary switch
Operator Qualifi cations
1 Tape loading and threading 1
2 Tape web alignment 1
3 Adjustment of one way tension roller 1
4 Adjustment to box size (H and W) 1
5 Top fl ap compression rollers 1
6 Adjustment of tape applying spring 1
7 Conveyor bed height adjustment 1
8 Special Adjustment-Changing tape leg length 2
9 Special Adjustment-Column re-positioning 2
12.7 Table of Operation Adjustments -
12.2 Starting the Machine
Important: Before starting the machine, verify that
no tools or other objects are on the conveyor bed.
Push the main rotary switch ON
(Figure 12-3) after
the EMERGENCY BUTTON is released.
2010 January
700rks-NA
Figure 12-1
Once the box has been
fi lled, close its top fl aps and
push it between the top and
bottom drive belts. Always
keep hands in position as
shown in Figure 12-2.
The box will be automati-
cally sealed with adhesive
tape on the top and bottom
box seams. Then the box
will be expelled on the exit
conveyor.
Figure 12-2
Hand Position
Figure 12-3
• To reduce the risk associated with sharp
blade hazards:
− Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
WARNING
To Next Page
Loading...
