3M 40800 - Box Height Combinations

16
2010 January
700rks-NA
Specifi cations (continued)
Special modifi cations may be available for carton sizes not listed on previous page.
Contact your 3M Representative for information.
Note: The case sealer can accommodate most boxes within the size range listed above. However, if
the box length (in direction of seal) to box height ratio is .6 or less, then several boxes should be
test run to assure proper machine performance.
DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:
BOX LENGTH IN DIRECTION OF SEAL
SHOULD BE GREATER THAN .6
BOX HEIGHT
Any box ratio approaching this limitation should be test run to assure performance.
=
Minimum/Maximum Box Height Combinations
(To re-locate upper frame or outer columns, see "Special Set-Up Procedure".)
Note: Length of boxes in illustrations above are not to scale.
Case Height Range Illustration
Upper Frame
Low Position
Outer Column
Position 1
Outer Column
Position 1
Upper Frame
High Position
Minimum / Maximum
105mm 630mm
[4.125in] [24.8125in]
Minimum / Maximum
235mm 813mm
[9.25in] [32.00in]
Minimum / Maximum
144mm 722mm
[5.6875in] [28.4375in]
Minimum / Maximum
244mm 822mm
[9.625in] [32.375in]
Minimum / Maximum
152mm 730mm
[6.00in] [28.75in]
Minimum / Maximum
327mm 905mm
[13.25in] [36in]
Outer Column
Position 2
Outer Column
Position 3
Outer Column
Position 2
Outer Column
Position 3
Upper Frame
High Position
Upper Frame
Low Position
Upper Frame
Low Position
Upper Frame
High Position
Box
Box
Operating
Range
Box
Box
Operating
Range
Box
Box
Operating
Range
Box
Box
Operating
Range
Box
Box
Operating
Range
Box
Box
Operating
Range