42
3M
™
Pocket Projector MP220
© 2012 3M. All Rights Reserved.
Remove Protective Film
Before you can begin using the battery, you must remove the protective film from
the battery compartment. Remove the film as shown below.
Using the Remote
When using the remote control, point the remote control's infrared transmitter at the
receiver on the projector. The receiver is beside volume up button.
Note: Sun light and some indoor lighting may reduce the range of the remote
control.
Replacing the Remote Battery
Replace the battery in the remote control with a CR2025 battery.
1 Remove the battery and
battery tray by holding latch
toward the center of the
tray and then pull the tray
out of the remote control.
latch
2 Place the new battery into
the tray and orientating the
battery positive size (+) as
indicated on the tray.
3 Finally Slide the tray into the
remote Control.
To Next Page
Loading...
Need help?
General
