3xLogic VISIX S-Series User Manual

VISIX S-Series Network Camera | USER MANUAL v6.0
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
12
Figure 2-5 Accessing the Camera through Router with Static IP
Connecting the network camera with static IP directly:
You can also save the static IP in the camera and directly connect it to the internet without using a router. Refer to
Detecting and Changing the IP Address
for detailed IP address configuration of the camera.
Figure 2-6 Accessing the Camera with Static IP Directly
DYNAMIC IP CONNECTION
Before you start:
Please apply a dynamic IP from an ISP. With the dynamic IP address, you can connect the network camera to a
modem or a router.
Connecting the network camera via a router:
Steps:
1). Connect the network camera to the router.
2). In the camera, assign a LAN IP address, the subnet mask and the gateway. Refer to
Detecting and
Changing the IP Address for detailed LAN configuration.
3). In the router, set the PPPoE user name, password and confirm the password.
4). Set port mapping. E.g. 80, 8000, and 554 ports. The steps for port mapping vary depending on different
routers. Please call the router manufacturer for assistance with port mapping.
5). Apply a domain name from a domain name provider.
6). Configure the DDNS settings in the setting interface of the router.
7). Visit the camera via the applied domain name.

3xLogic VISIX S-Series Specifications

General

Brand	3xLogic
Model	VISIX S-Series
Category	Security Camera
Language	English