4 Basic Operation
4.1 Configuring Local Parameters
The Local Configuration settings allow the user to set the parameters for live view, recorded files and captured
pictures/stills. The recorded files and captured pictures/stillshots can be captured using the camera’s browser
UI and are saved to a destination path on your local system.
Steps:
1. Enter the Local Configuration interface: Configuration > Local.
Figure 4-1 Local Configuration Interface
2. Configure the following settings:
Live View Parameters:
Set the Protocol Type and Live View Performance settings.
Protocol Type: TCP, UDP, MULTICAST and HTTP are selectable.
► TCP: Ensures complete delivery of streaming data and better video quality, however, real-
time transmission will be affected (skipped frames, etc…)
► UDP: Provides real-time audio and video streams though video quality may be lowered
due to bandwidth limitations.
► HTTP: Allows the same quality as TCP without setting specific ports for streaming under
some network environments.
► MULTICAST: It’s recommended to select MCAST type when using the Multicast function.
For detailed information about Multicast, refer to
Section 9.1 Configuring Basic Settings –
Configuring TCP/IP Settings.
Play Performance: Set the play performance to Shortest Delay or Auto.
Rules: Refers to on-screen tracking for rules configured on the camera. Select enable or disable to
display or not display colored trackers when motion detection, face detection, or intrusion detection
is triggered. E.g., If face detection is enabled and this option is active, when a face is detected it will
be marked with a green rectangle on the live view.
Image Format: Choose the image format for picture/stillshot capture.
Record File Settings
Set the destination of recorded video files. Applies only for video recorded manually via the browser UI.
Record File Size: Select the packed size of the manually recorded and downloaded video files to
To Next Page
Loading...
Need help?
General
