Copyright © 2017, 4ipnet, Inc. All rights reserved. All other trademarks mentioned are the property of their respective owners.
TX STBC: STBC is a pre-transmission encoding done by MIMO transmitter that allows it to improve the
signal-to-noise ratio even at a single RF receiver (non-MIMO).
Multicast/Broadcast Rate: Bandwidth configuration for multicast/broadcast packets. If your wireless
clients require a larger or smaller bandwidth for sending multicast/ broadcast packets, the administrator
can customize the Access Point’s multicast/ broadcast bandwidth here.
Management Frame Rate: This feature controls the bandwidth for Management Frames. The higher
the rate it, the shorter range the transmission covers
Receiving RSSI Threshold: To ensure connected stations have quality connection speeds, a station will not be
able to associate to the network unless its receiving sensitivity meets the configured threshold.
To Next Page
Loading...
