AAON WH Series User Manual

WH Series Startup Form
Job Name:_______________________________________________ Date:______________
Address:______________________________________________________________________
______________________________________________________________________________
Model Number:_________________________________________________________________
Serial Number:_____________________________________________
Tag:_______________
Startup Contractor:______________________________________________________________
Address:______________________________________________________________________
_______________________________________________________
Phone:______________
Pre Startup Checklist
Installing contractor must verify the following items.
1. Is there any visible shipping damage?
Yes No
2. Is the unit level?
Yes No
3. Are the unit clearances adequate for service and operation?
Yes No
4. Have all electrical connections been tested for tightness?
Yes No
5. Does the electrical service correspond to the unit nameplate?
Yes No
6. On 208/230V units, has transformer tap been checked?
Yes No
7. Has overcurrent protection been installed to match the unit nameplate
requirement?
Yes No
8. Have all set screws on the fans been tightened?
Yes No
9. Does the fan rotate freely?
Yes No
10. Does the field water piping to the unit appear to be correct per design
parameters?
Yes No
11. Is all copper tubing isolated so that it does not rub?
Yes No
12. Are air filters installed with proper orientation?
Yes No
13. Have condensate drain and p-trap been connected?
Yes No
Ambient Temperature
Ambient Dry Bulb Temperature ________°F Ambient Wet Bulb Temperature ________°F

AAON WH Series Specifications

General

Brand	AAON
Model	WH Series
Category	Heat Pump
Language	English