Model 55i IP Phone User Guide 107
Line Keys, Programmable Keys, and Softkeys
Empty Key (softkeys only)
You can set a softkey to force a blank entry on the IP phone display for a specific key.
You do this by setting the softkey to "empty". The keys are added in order (from key
1 to key 20) after any hard-coded keys have been added. If a particular key is not
defined, it is ignored.
Setting an Empty Key
Use the following procedure to configure an Empty softkey on the 57i phone.
1. Click on Operation->Softkeys and XML.
or
Click on Operation->Expansion Module <N>.
2. For softkeys, select from "Key 1" through "Key 20".
3. In the "Type" field, select Empty.
4. When configuring a softkey, in the state fields, check (enable) or uncheck (dis-
able) the states you want to apply to this softkey.
5. Click to save your changes.
Aastra Web UI
To Next Page
Loading...
