12 Model 6757i CT IP Phone Installation Guide
Installation and Setup – 6757i CT Base Unit
Installation and Setup – 6757i CT Base Unit
The 6757i CT base unit can be setup to share a network connection with
another network device. Power can be provided by an AC adapter, an
802.3af compliant network power source or with a PoE inline power
injector (optional accessory). It can also be installed on a desk or mounted
on the wall. If your Network Administrator has already setup your
phone, please refer to the Aastra IP Phone 6757i CT
User Guide for call
handling information or contact your Network Administrator.
Direct or Shared Network Connection
The phone can be set up as a direct network connection to the Ethernet wall
jack or as a shared network connection as a pass-through if connecting a
computer or another network device to the phone.
Direct Network Connection
Located at the top of the phone are two fully switched 10/100 Mbps
Ethernet cable ports. The port marked with
LAN is used to connect the
phone to the network, as well as provide power to your phone (if
required). See the section "Connecting to the Network and to Power" on
page 14 for more information.
To Next Page
Loading...
