Aastra Dialog 4422 IP Office - IP Declaration and Start-Up of Your Extension; Declaring Your Extension’s IP Network Parameters

135MD Evolution – Dialog 4422 IP Office
IP Declaration and Start-Up of Your Extension
IP Declaration and Start-Up of Your
Extension
The first time you use your Dialog 4422 IP Office extension, once it
has been connected to the power supply and your company’s LAN,
it is necessary for it to be configured for your company’s IT network.
This is usually carried out by your system administrator only once,
at the time of installation. However, this section does provide you
with the instructions to do this yourself, or at least to know how to
access your extension’s IP environment characteristics that you may
need to provide to your system administrator if a problem arises
with your extension.
This section also provides you with information concerning the
process of starting up your extension.
Declaring Your Extension’s IP Network
Parameters
To manage your extension’s IP environment characteristics within
your company’s IT network, from an idle extension:
í*5 Begin by simultaneously pressing and holding all three of the
keys shown on the left for approximately one second.
This is required in order to modify your extension’s IP network para-
meters; however, by default, this information may only be consulted,
not modified. An acceptance confirms your request.
Settings Press the Settings key on your extension.
You then access the physical programming of your extension